User's Manual

Note

• If you configure the CPE router from a wireless computer, you must add your computer’s MAC address into the

access control list. Otherwise, you will lose your wireless connection when you click “Apply.” In this case, you must

access the router from a computer connected via wire, or from a wireless computer, then set the allowed MAC address,

into the access control list, to make any further changes.

Device Security Menu

 Device Security Settings

Device security related configuration setting. Enable or Disable use of “Access Control” feature to allow access to the

GUI for specific user.

 Access Control

Access to the CPE device is restricted to IP Addresses listed here. For instance, you can restrict access to the local

network to allow only specified computers based on their IP addresses, meaning that you can restrict access to only

trusted computers so that unknown computers will not be available to access your CPE device.