User's Manual

Note

• Before the WPS activity, we recommend removing the router’s Wi-Fi profile stored on your device (personal

computer, laptop, smartphone), and then push the ‘Start PBC’ button or press the ‘WPS button’ on the router. The

device should connect in about two minutes after pressing the WPS button, if there is no connection within two

minutes, the router will restart.

• Only supports 1:1 connection between the router and device (i.e., personal computer, laptop, and smartphone), the

WPS function will be operating as the WPA type’s security. If you want to use the WPS function with the WPA2 security,

client OS version must be more current than Windows XP Service Pack 3. Also please remove the router Wi-Fi profile

stored on your device.

• If you want to use a WPS PIN (Personal Identification Number), the client device must support a WPS PIN application

located in the WPS configuration utility. To run the WPS PIN procedure, please see the below steps.

- 1) Go to the client wireless computer and run the client WPS configuration utility and generate a PIN number.

- 2) Notate the client PIN number.

- 3) In the WLAN Wi-Fi protected setup Web page, there is a PIN inputting method for ‘Enter Client Device PIN’

item.

- 4) Enter the client PIN number noted and press the WPS button. The device will begin trying to make a

connection which should takes approximately 4 minutes.