User's Manual

WPS Configuration

Any wireless computer or wireless adapter that connects to the router wirelessly is a client. The client of your

computer’s system must support a WPS button and also must have a WPS configuration utility. The WPS method is

used to easily add devices to the Wireless network using a PIN or a push button. Please note the client’s devices must

support WPS capability in order to be configured by this method.

To setup the WPS feature between your CPE router and your client, follow the below steps

① Login to

your CPE router through Web UI. (See more detail in Chapter 4)

② Go to ‘WLAN Wi-Fi Protected Setup’ item in WPS Settings of Wireless menu.

For PBC (Push Button Configuration) method, it will be operated by the WPS button on the C774 router.

③ Push the ‘Start PBC’ button or press the ‘WPS button’ on the router.

A. The router will try to make a connection with client device (i.e., personal computer, laptop,

smartphone) which will take approximately two minutes.

B. During the WPS operation, the router’s Wi-Fi LED will be blinking Blue.

④ Go to the client wireless computer, run a WPS setting utility and click a WPS button in the utility’s instruction.

A. If the WPS operation is done, the router’s Wi-Fi LED will be lit.

⑤ Go back to the router’s Web UI, and check the Wi-Fi status whether the client is connected or not.