Installation Owner manual

SERVICE, TROUBLESHOOTING, WARRANTY REGISTRATION Page 10 - 9 10
Correct wiring and re-configure (choose AUTO CONFIGURE SENSORS from the
SENSORS setup menu and wait about 10 minutes for the type-identification
process to finish. The
WAIT... display will disappear when done).
#15 — Verify System Operation
Normal tank gauge function can be verified by the absence Alarms or Error
messages (none shown in this chapter) and by the
DISPLAY OUTPUT or
production of TIME-STAMPED & DATED REPORTS (such as Product Inventory
Detail Reports). Product Inventory Reports can be produced if the system is
functional (product level, percent full/capacity and other data is shown on this report
– see typical reports). With some systems ( T1 T2 ) leak detection sensors can also
be tested to verify that the sensors work with the system and that they produce
appropriate alarms.
Warranty Registration
After installation, make sure to return the Warranty Registration form to
INCON. This form validates the warranty as stated in INCON documents
000-1197 and 000-1124.
For further Warranty or RMA Information
Need Help ? Contact INCON Technical Service for help with the installation,
and about Warranty, or RMA issues, and about restocking charges and
correct return–shipping address.
Please call if alarms, warnings, or error codes occur frequently or repeatedly.
Office Hours: 8 a.m. to 5 p.m. EST Monday through Friday
Sales 24 hour Technical Service
Phone: [phone] Phone: [phone]
[phone] [phone]
Fax: [phone] Fax: [phone]
E-mail: [e-mail] E-mail: [e-mail]
Visit our web site at: www.incon.com
—
❖
—
NOTE