Installation Owner manual

SYSTEM START-UP Page 8 - 1

8 System Start-up

Before System Start-up – Check

Before turning the Tank Sentinel console and system power on, thoroughly check

all wiring and installation details of the system, including the following:

❐ AC power wiring and accessory wiring is in metal conduit.

❐ AC power is wired correctly in accordance with Figures 7-3a or 7-3b.

❐ All probe cables and sensor wiring is in threaded, rigid metal conduit.

❐ All conduit and junction boxes are dry and weatherproof.

❐ All conduit, and all threaded fittings are sealed with pipe dope.

❐ All Intrinsically Safe (I.S.) probe and sensor wiring are within conduit/pull boxes and

are separate from all other (non-I.S.) wiring.

❐ EYS Seal fittings are installed in all probe and sensor circuit conduits, and are

sealed with epoxy.

❐ The proper level probe cables have been installed per TABLE 7-3.

❐ Level probes are wired in accordance with Figures 7-4 & 7-5.

❐ Leak detection sensors have been installed per their manuals.

❐ Cable compression gland fittings (cord grips) are correctly installed, sealed, and

tightened on all junction boxes and riser caps.

❐ Thread sealant or pipe dope was used on all threaded conduit, pipe joints, and

compression fittings producing a watertight seal.

❐ Riser pipes are installed and sealed in accordance with this manual.

❐ Probes have been installed in accordance with this manual and have been adjusted

to be 1/4” (6 mm) off the bottom of the tank.

❐ All safety covers/shields have been reinstalled in the console.

❐ All probe and sensor riser caps are in place and latched/tightened.

Power Up

After the system has been thoroughly wired and checked-out you may apply power.

Turn the Tank Sentinel system circuit breaker ON at the Electrical Power Panel and

move switch SW1 within the console to the ON position (Ref: Figure 7-3a). The

display will show a start-up message for several seconds and then will indicate the

system software version number. These displays will appear as follows:

Product Codes:

= TS-1001,

= TS-2001,

= TS-504,

= TS-750,

= TS-508,

none = all products