Installation Owner manual

7 Page 7 - 30 TANK SENTINEL
®
INSTALLATION GUIDE
TS-IEM PC Board (Shown with 5 different types of I/O Modules)
WARNING: External power sources present... Avoid electrical shock hazards and equipment damage - DO NOT install or remove modules, fuses, or wiring with power on ! - Locate, disconnect, and check all external power sources for absence of voltage and turn the TS-2001 Power off before working on these circuits.
AC NEUTRAL
DC LOAD
DC LOAD
- DC POWER SOURCE RETURN
+ DC POWER SOURCE + DC POWER SOURCE
- DC POWER SOURCE RETURN
MT
IN4005 COMMUTATING DIODE FOR INDUCTIVE LOADS
IN / O U T 8 IN / O U T 6 IN / O U T 7
AC LOAD
DC SIGNAL
AC SIGNAL
AC NEUTRAL
+ DC POWER SOURCE
- DC POWER SOURCE RETURN
AC POWER SOURCE
C
AC POWER SOURCE
C
NC
NO
IN / O U T 5 IN / O U T 4 IN / O U T 2 IN / O U T 3
NC
NO
IN / O U T 1
MT
(5 - NO DIGITAL AC OUTPUT)
RL5
F4A
W
(8 - NO/NC DRY CONTACT OUTPUT)
(7 - NO DIGITAL DC OUTPUT)
J1
F4A
RL8
170- 1058
250V
W
S
x
F4A
RL7
+DC-
AC
RL6
+DC-+DC-
AC AC
FU S E FU S E
250V
x
W
S
250V
MT
(3 - DIGITAL DC INPUT) (1 - DIGITAL AC INPUT)
+DC- +DC-
RL4
+DC-
AC
+DC-
AC
RL3
AC
+DC-
AC
x
S
FU S E
RL2 RL1
J2
AC
MT
( T2 )
Figure 7-13d. TS-IEM Typical Wiring Diagram