Installation Owner manual

SYSTEM WIRING Page 7 - 15 7
Figure 7-8a. TS-SEM BriteBox
®
— Typical Installation
Figure 7-8b. TS-SEM BriteBox
®
— Overall Mounting Dimensions
TS-KB BRITEBOX - TO - BRITEBOX
SPI BRITEBUS RIBBON INSTALLATION KIT
(CABLE WITHIN)
8" Max.
(203.4 mm)
# 17 - 20
TO LEAK
DETECTION
SENSORS:
# 25 - 28
TS-SEM BRITEBOX
# 2
# 21 - 24
INTELLIGENT CONTROLS INC.
SAC O, MAIN E 04072
74 INDUSTRIAL PARK ROAD
SENSOR
EXPANSION MODULE
# 13 - 16
TS-SEM BRITEBOX
# 1
SENSOR
EXPANSION MODULE
INTELLIGENT CONTROLS INC.
SACO, MAINE 04072
74 INDUST RIAL P ARK RO AD
ONE OR TWO TS-SEM BRITEBOXES
MAY BE CONNECTED TO THE
TS-1001 / TS-2001
TANK SENTINEL SYSTEM
(TS-1001 Console Shown)
TS-KB - - USE THE 3/4" (19.1 mm)
SPI CONDUIT KNOCKOUT AT THE
CONSOLE.
(BRITEBUS RIBBON CABLE WITHIN)
SPACE
ENTER
DOW N
+/-
CANCEL
CANCEL
FEED
SE TUP
REPORT
WATER
LEVEL
7 8 9
ACK
SHIF T
TEST
0 .
L Y M
MENU ALARM
PRODUCT
H
TANK
D
4
1
U
I
V
J
ULLAGE
Q E
5
R F
6
GROS S
2 3
A
N
B
O
C
Z
W
S
K
G
P
X
UP
T
ENVIRONME NTAL CONTROLS D IVISION
TEST
ALAR M
TS-1001 TANK SENTINEL
ALARM
STATUS
M 1 M 2
POW E R
WARNINGS
M 3 M 4
SYSTE M
OKAY
TANK
OKAY
SENSOR
OKAY
R
TURN POWER OFF BEFORE INSTALLING ANY BRITEBOX OR
SENSOR. REPLACE I.S. COVER BEFORE TURNING POWER
BACK ON (AFTER ALL WIRING IS COMPLETE).
( with cover off )
4.92
(125)
2.95
(74.9)
I.S. COVER
SERIAL No. LABEL
4.22
(107.2)
6.89
(175)
J2
(4) #8
HOLES
6.18
(157)
F1
J1D1
Dimensions are listed in inches (mm)
SENSOR
EXPANSION MODULE
74 INDUSTRIAL PARK ROAD
SACO, MAINE 04072
MODEL TS-SEM
BriteBox™
WARNING
THIS COVER MUST BE INSTALLED TO MAINTAIN
INTRINSIC SAFETY ! OPERATING THE SYSTEM WITH
THIS COVER REMOVED COULD RESULT IN AN
EXPLOSION HAZARD. CONSULT THE INSTALLATION
MANUAL FOR MORE INFORMATION.
CONDUIT SPECIFICATIONS
BRITEBUS™: 3/4 INCH
CONDUIT OPENING
(Upper).
SENSORS: 3/4 INCH
CONDUIT OPENING
(Lower).
FOR INTRINSICALLY SAFE
CIRCUIT WIRING ONLY.
1/2 INCH CONDUIT
OPENING (Bottom of Box)
FOR INTRINSICALLY SAFE
(I.S.) GROUND WIRING ONLY.