Owner's manual

ManualsBrandsFranklin Fueling Systems ManualsEquipmentMain System Board for Tank Sentinel, AutoStik, BulkStik ATGs

www.franklinfueling.com

0000200 REV C

E-mail: tech@franklinfueling.com FAX 1-207-282-9002 TEL 1-800-984-6266 PAGE 1 of 4

sales@intelcon.com FAX 1-207-283-0158 TEL 1-800-872-3455

REPLACEMENT

PART

INSTRUCTIONS

Main System Board Installation for Tank Sentinel, AutoStik, BulkStik ATGs

TS-1001/N-N U10

VER No. DATE

Diagram: A Tank Sentinel (Except TS-2001), AutoStik Jr, BulkStik, AutoStik II (1-4ch)

050-0200

1001/2001 (U10)

REV. / VER N.NN

Diagram: B TS-2001, AutoStik II (8 Ch)

Summary of content (4 pages)

PAGE 1
REPLACEMENT PART INSTRUCTIONS www.franklinfueling.com 0000200 REV C Main System Board Installation for Tank Sentinel, AutoStik, BulkStik ATGs TS-1001/N-N U10 VER No. DATE Diagram: A Tank Sentinel (Except TS-2001), AutoStik Jr, BulkStik, AutoStik II (1-4ch) 050-0200 1001/2001 (U10) REV. / VER N.NN Diagram: B TS-2001, AutoStik II (8 Ch) E-mail: tech@franklinfueling.com sales@intelcon.
PAGE 2
Tank Sentinel ® Replacement Part Instructions 0000200 REV C Need: Digital multimeter to read Voltage, screw drivers, and marking tape and pen. Parts Supplied (Documents 000-0200, -0205, -0206, 0207, -0211, -0212, -0213) and: 1.) Main System Board (MSB) for Tank Sentinel, AutoStik Jr, BulkStik console (See Diagram A) — or — 2.) Main System Board (MSB) for the TS-2001, & AutoStik II (See Diagram B) and 3.) Packaging and Large Electronic Component anti-static bag (reuse to ship the old MSB back to INCON...
PAGE 3
Tank Sentinel ® 7.) Replacement Part Instructions 0000200 REV C Remove the TS-2001/AutoStik II: TS-IEM Power Safety Shield and verify that no voltage / power is present... disconnect all power before proceeding. DO NOT remove wires terminating at the TS-2001 TS-IEM PC Board(s) …the TS-IEM interface board(s) will not be taken out-of the console. 8.) Remove the support hardware from the TS-IEM PC Board(s) and unplug these from the MSB (see P/N 000-0212 for instructions). 9.
PAGE 4
Tank Sentinel ® Replacement Part Instructions 0000200 REV C 5.) Use a flat bladed screwdriver to install the upper right and lower left hold-down screws at transformer T1 (verify that all 4 tubular nylon spacers are still in place). 6.) Use the Phillips bladed screwdriver to install the four metal hold-down screws into the four corners of the MSB. Make sure the green ground wire, ring-lug, is also held-down by one of these screws. 7.) Ground yourself again – touch the bare metal of a metal conduit.