SDS

4. First-aid measures
Inhalation
Move to fresh air. Call a physician if symptoms develop or persist.
Skin contact
Wash off with soap and water. Get medical attention if irritation develops and persists.
Eye contact
Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if
present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.
Ingestion
Rinse mouth. Get medical attention if symptoms occur.
Most important
symptoms/effects, acute and
delayed
Irritation of eyes. Exposed individuals may experience eye tearing, redness, and discomfort.
Indication of immediate
medical attention and special
treatment needed
Provide general supportive measures and treat symptomatically. Keep victim under observation.
Symptoms may be delayed.
General information
Ensure that medical personnel are aware of the material(s) involved, and take precautions to
protect themselves.
5. Fire-fighting measures
Suitable extinguishing media
Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).
Unsuitable extinguishing
media
Do not use water jet as an extinguisher, as this will spread the fire.
Specific hazards arising from
the chemical
During fire, gases hazardous to health may be formed.
Special protective equipment
and precautions for firefighters
Self-contained breathing apparatus and full protective clothing must be worn in case of fire.
Fire-fighting
equipment/instructions
Move containers from fire area if you can do so without risk.
Specific methods
Use standard firefighting procedures and consider the hazards of other involved materials.
General fire hazards
No unusual fire or explosion hazards noted.
6. Accidental release measures
Personal precautions,
protective equipment and
emergency procedures
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Wear
appropriate protective equipment and clothing during clean-up. Do not touch damaged containers
or spilled material unless wearing appropriate protective clothing. Ensure adequate ventilation.
Local authorities should be advised if significant spillages cannot be contained. For personal
protection, see section 8 of the SDS.
Methods and materials for
containment and cleaning up
Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is
possible. Cover with plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth
and place into containers. Prevent product from entering drains. Following product recovery, flush
area with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS.
Environmental precautions
Avoid release to the environment. Contact local authorities in case of spillage to drain/aquatic
environment. Prevent further leakage or spillage if safe to do so. Do not contaminate water. Avoid
discharge into drains, water courses or onto the ground.
7. Handling and storage
Precautions for safe handling
Avoid contact with eyes. Provide adequate ventilation. Wear appropriate personal protective
equipment. Observe good industrial hygiene practices. Avoid release to the environment. Do not
empty into drains.
Conditions for safe storage,
including any incompatibilities
Store in original tightly closed container. Store away from incompatible materials (see Section 10
of the SDS).
8. Exposure controls/personal protection
Occupational exposure limits
No exposure limits noted for ingredient(s).
Biological limit values
No biological exposure limits noted for the ingredient(s).
2 / 6
Material name: T.E.T. Neutral Floor Cleaner
1448 Version #: 01 Issue date: 03-09-2015
SDS US