Manual

2. Using the Rotary Brass Separator:
a. Lock the separator into the bucket adapter by
placing the axle pin into the hole in the bottom
of the “U” groove of the bucket adapter
(picture 4).
b. Open the separator by squeezing the latches
together and tip the top sifter half back against
the bucket adapter (picture 5).
c. Pour the contents of the tumbler into the
separator and close it, making sure the latch
locks securely.
d. Lift the separator axle on one side until the axle
pin is free from the hole in the bottom of the
“U” groove.
e. Slide the separator to the left, unlocking the axle
pin and allowing the sifter to rotate (picture 6).
f. Rotate the separator body with your hands to
separate the media and brass.
g. Place the separator into the locked position on
the bucket adapter (see item 2a. above).
h. Open the separator, tip the top half back and twist slightly to disengage the
hinges. Remove the top half.
i. Remove the bottom half of the separator with the cartridge cases and place
it next to your reloading press. The separator will lay flat.
Picture 4
Picture 5
Picture 6