Manual

4. If the top of your powder pan sits
higher than 2-1/8" from your work
surface, install the trickler stand on
your trickler by holding the stand at
a 90º angle to the main trickler with
latch held up against the switch side
of the trickler. Slowly rotate the
stand until it is latched in place (see
figure 2).
Using the Jiffy
™
Powder Trickler:
1. Place the trickler on your work surface next to your scale with the
hole in the dispensing tube facing up. Making sure you have the cor-
rect powder, slowly pour it into the powder hopper until it is approxi-
mately 3/4 full.
2. Position the trickler so the switch is in a convenient location and the
dispensing tube is over the scale pan.
3. To prime the tube, slowly incline the unit lowering the dispensing
tube until powder flows into the scale pan. Make sure the trickler
doesn’t interfere with the operation of the scale.
4. Make sure the o-ring is lying in the groove on the dispensing tube.
Zero your scale, then push the trickler button and watch the scale.
When the scale indicates you are getting close to your desired charge,
release the button and let the scale stabilize. At this point, you can
use a start-and-stop method of dropping powder and checking the
scale until you have the exact charge weight.
5. When measuring large powder charges, you may want to dispense the
bulk of the charge with a powder measure or powder dipper and then
use the electric powder trickler to bring the powder charge to the
desired weight.
Figure 2