Installation Sheet

TECHNICAL DATA
NOTE:
CONTENTS IN BOX
1 Faucet assembly
2 Escutcheon
INSTALLATION INSTRUCTIONS
1
Contact us immediatly if you see inconsistencies.
Phone: [phone])
website: www.franke.us/ks
email: [e-mail]
1. For best results, Franke recommends this faucet be installed by a
licensed, professional plumber. Please read over the instructions before
beginning the installation. Make sure to observe all local plumbing and
building codes during installation of this faucet.
2. Remove all contents from the package and check for completeness.
3. Turn o cold water supply.
4. This faucet requires a ½” NPT male nipple (6) at the desired faucet
location for proper installation. The nipple must have adequate bracing
to support the weight of the faucet.
ATTENTION: The faucet should be connected to cold water only!
5. The water supply nipple (6) should extend from the nished wall
1/2” minimum and 9/16 “ maximum as shown in gure 1.
NOTE: For steps 6-10, refer to gure 2.
6. Install the pin handle set screws (4) into the handle (3) with a 2.5 mm
allen key as illustrated. Thread the pin handles (5) onto the set screws (4)
hand tight.
7. Apply thread sealing tape or thread sealant onto the cold water supply
nipple (6).
8. Slide the escutcheon (2) onto the faucet body (1) and thread the faucet
body onto the water supply nipple (6).
9. Tighten body until connection is water tight and the faucet is level
10. Slide the escutcheon down the faucet body (1) against the nished
mounting surface
11. Remove the aerator using a 7/8” (22mm) wrench and turn on the water
and let it run for several seconds to ush any debris from the faucet.
While the faucet is on check for leaks. Turn o the faucet and reinstall the
aerator – see gure 3
Flow Rate
Recommended Water Pressure
Max. Water Pressure
Hole Size For Faucet
Certies this faucet complies with ASME A112.18.1 / CSA B125.1
& NSF 61, NSF 372 and AB1953
2 GPM at 60 PSI
30-75 PSI
145 PSI
1 3/8”
2
2
1
3
3
3
3
4
4
3 Pin handle set screws x 2
4 Pin handles x 2
4
5
4
5
9/16” max
6
Figure 1
Figure 2
Figure 3
2.5 mm
2.5 mm
1/2” min