Installation Guide

Step 3: Applying Mounting Clips
1.
2.
3.
Assemble screws into the clamps as shown in Step
A. (Screws insert into clamps with a reverse thread.)
Locate the clamps in the position shown in Step B.
Hand tighten each clamp onto the channel so that the clamp teeth point in the same direction as the channel.
Locate the clamps uniformly around the sink making sure to locate one in the middle of each side.
Remember only hand tighten the clamps at this time.
Step 3: A Step 3: B
Rail
Front Rim
ClipClip
Clip
Clip
ClipClip
Clip
Clip
Clip
Clip
Clip
Clip
Turn speed screw counter
clockwise to hand tighten
Speed
Screw
Clamp
Channel
Rail
Front Rim
ClipClip
Clip
Clip
ClipClip
Clip
Clip
Clip
Clip
Clip
Clip
Turn speed screw counter
clockwise to hand tighten
Speed
Screw
Clamp
Channel
STEP 2:
OPTION A: Prepare existing countertop
Make sure existing countertop cut-out opening is the proper size. Set the new sink into
opening. The sink rim should rest evenly on the countertop. Slight adjustments can be
made using a file or a jigsaw.
Use caution to avoid chipping or cracking the countertop while filing or sawing.
After final fitting, remove the new sink from cut-out.
1.
2.
3.
Carefully place the sink upside down on the
countertop at the desired position. Trace the
outline of the sink onto the countertop. Do not
cut along this line.
Draw a line 5/16" (8mm) inside the sink outline.
Measure the cut-out line you just drew and
compare to all sink dimensions. The cut-out
should be approximately 5/8" (16mm) smaller
than the overall sink dimensions.
Verify both measurements.
Drill a pilot hole inside the cutting line.
Using a jigsaw, cut along the inside line to create the opening in the countertop.
1.
2.
3.
4.
5.
A template is provided to use in cutting the sink hole.
Template can be located either:
A. On the outside of the sink carton. Use scissors
to cut along dotted line. Measure the cut-out line
and compare to all sink dimensions.
B. Inside carton. Measure the cut-out line and
compare to all sink dimensions. The cut-out line
should be 5/8" (16mm) smaller than the overall sink
dimensions.
Place template on countertop. Trace completely around
the edge of the template directly onto your countertop.
Drill a pilot hole inside the cutting line.
Using a jigsaw, cut along the inside line to create the
opening in the countertop.
1.
2.
3.
4.
Attach faucet and drains to the sink. Use plumber’s putty or silicone sealant under
the faucet base and under the top flange of the drain to provide a leak-proof seal.
OPTION B: Prepare a new countertop
using the sink as a template
OPTION C: Prepare a new countertop
using the cut-out template provided
STEP 4: Install accessories
OPTION C: 1
2
43
OPTION B: 1
4
2
5
Step 4
Step 2