Installation Guide

3 Step Three: Knocking Out Faucet/
Accessory Holes (Must be done before
installing sink)
If your sink already has the proper number of
holes needed, you can proceed to Step Four.
If additional holes need to be knocked out,
place the sink upright on a stable workstation
(a workbench or the  oor). Do NOT place the
sink in the countertop to knock out the holes,
as damage could occur such as cracking or
breakage. Locate the round stickers on the ledge
of the sink. These stickers represent the locations
of the partially drilled holes. With a hammer and
punch or nailset, you can knock out the partially
drilled holes needed for faucet and accessories.
You will then use a  le (ex: rattail type) to
smooth away any rough surface in the holes.
Note: any additional holes beyond the partially
drilled ones noted on this sink are considered
modi cations and any problems associated with
these holes are not covered by the warranty.
4 Step Four: Seal Countertop
Place a thin bead of silicone sealant around
the perimeter of countertop cutout. This will
ensure that the sink is completely sealed to
the countertop.
Caution: Do not use Plumbers Putty! Plumbers
Putty can stain your sink.
5 Step Five: Attach Faucet and
Accessories
To simplify installation, we recommend
the installer attach faucets, strainers and
accessories at this time.
When  tting the drain to the sink, take extra
care not to overtighten. Overtightening can add
a mechanical stress in the region of the drain
hole which could damage or crack the sink. We
recommend the screw  tting be hand tight plus
one eighth turn.
Caution: Do not use Plumbers Putty! Plumbers
Putty can stain your sink.
6 Step Six : Mounting Brackets
Assemble the mounting clips and bolts as
shown in the diagram. Our tests have shown
that the six clips provided are more than
adequate to hold your sink in place until the
sealant applied in Step Four is dry.
7 Step Seven: Hook up plumbing, check
for leaks.
4
Countertop
Top ange
of the
drain
Faucet base
Silicone Sealant
Sink bottom
Hand tighten
plus 1/8th of a turn
5
Countertop
Mounting Clip
(furnished)
Fastener
(not furnished)
Sink
Silicone Sealant
(not furnished)
6
TOPMOUNT
INSTALLATION
continued from page 1
Marks partially drilled holes
Carefully knock out
only the required holes
3
NOTE: The illustrations
are a representation
of a sink and may
di er from the style
of your sink. The
instructions still apply
to your installation.
Granite_Install_Broch_EN_prod.indd 2Granite_Install_Broch_EN_prod.indd 2 2/25/11 4:43 PM2/25/11 4:43 PM