Installation Instructions

ManualsBrandsFranke ManualsDual-Mount Kitchen SinksDual Mount 20" Stainless Steel 3-Hole Single Bowl Utility Sink

Important: Professional Installation Recommended

Locate the position of the sink using the template provided

and make the cut-out from the countertop. Note: This

template will align the edge of the countertop to the

tangent of the top radius of the bowl (see illustration).

If there is a preference to show more reveal of sink

flange (lip), adjustments to the cut out need to be made

by installer.

Align the bowl under the countertop cut-out and

determine the location for the mounting brackets.

Mounting brackets have been supplied. Installer will

determine attachment method.

Attach the mounting brackets loosely to the countertop

from underneath, using the fastener and attachment

method recommended by the countertop supplier.

Undermount Installation

Place template on

countertop & co

rm where

to cut hole.

Countertop

Cabinet

Template

Step 1

Mounting bracket

(provided)

Wing nut & washer

(not provided)

Countertop

Epoxy

Silicone sealan

(not provided)

Sink

Step 2-5

Only use natural stone or solid surface countertops such as acrylic, granite, marble and other composite material

for undermount installations. Franke accepts no liability for damage to solid surface countertops or sink ﬁxtures

during installation. Because the mounting of undermount sinks to any countertop material is a specialized procedure,

we recommend that it be performed by a trained professional installer. Note: A cutting mistake will be costly. We

recommend comparing the template provided to the sink before cutting the countertop.

5. Do not overtighten. It is only necessary to draw the rim down snugly to the countertop.

6. Wipe excess sealant from perimeter with a wet cloth.

Step 6: Final Steps

1. Connect and tighten hot and cold faucet supply lines, strainer, drain and trap assembly. Note: Depending on the

the new sink installation.

2. Turn on water supply and examine all connections for leaks. If leak appears, tighten joint slightly. Do not overtighten.

4. Remove stopper and let water drain while examining drain connections for leaks.

Apply a continuous bead around the top flange (lip) of the sink.

Step 4 :

Apply silicone sealant or plumber’s putty

Align the bowl with the countertop cut-out from underneath and fully tighten the brackets against the sink flange (lip).

Step 5 :

Sink alignment and mounting

Step 1: Determine position of the sink

Step 2: Determine position of the mounting brackets

Step 3: Attach the mounting brackets