Installation Instructions

TRANSITIONINSTALLATION
WATERPROOF
SURFACE REDUCER
V-SR-14
Used to fill the gap between two
floors of unequal height.
Used with floors ranging from
2-6mm height.
Surface: Wear resistant
Core Material: Rigid PVC
Dimension: 1.77”w x 0.345”h
0.514˝
Measure and trim to fit.
Install the flooring leaving a 1-1/8” gap between
the two floor surfaces for the surface reducer
installation.
Starting at one end, press the molding into the
track inching along the length of the molding.
It will NOT snap in all at once. You may also use a rubber mallet.
Suboor
Linoleum Tile
1
1
/8
˝
Floor
Linoleum Tile
Suboor Suboor
Floor
1/4
˝
1/4
˝
Center the track between the flooring leaving a
1/4” spacing between the track and floor planks.
Screw track to subfloor using included screws
(or glue down with construction adhesive).
Linoleum Tile
Suboor Suboor
Floor