SDS

Laminate Floor Moulding
Safety Data Sheet
04/01/2015
EN (English US)
3/6
7.2. Conditions for safe storage, including any incompatibilities
Storage conditions
:
No special storage conditions required.
7.3. Specific end use(s)
No additional information available
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Polyvinyl chloride (9002-86-2)
ACGIH
ACGIH TWA (mg/m³)
1 mg/m³ (respirable fraction)
OSHA
Not applicable
Coating 1
ACGIH
Not applicable
OSHA
Not applicable
Coating 2
ACGIH
Not applicable
OSHA
Not applicable
4,4'-Methylenediphenyl diisocyanate (101-68-8)
ACGIH
ACGIH TWA (ppm)
0.005 ppm
OSHA
OSHA PEL (Ceiling) (mg/m³)
0.2 mg/m³
OSHA
OSHA PEL (Ceiling) (ppm)
0.02 ppm
Formaldehyde (50-00-0)
ACGIH
ACGIH Ceiling (ppm)
0.3 ppm
OSHA
OSHA PEL (TWA) (ppm)
0.75 ppm
OSHA
OSHA PEL (STEL) (ppm)
2 ppm (see 29 CFR 1910.1048)
Wood dust, all soft and hard woods (RR-00514-1)
ACGIH
Not applicable
OSHA
Not applicable
8.2. Exposure controls
Appropriate engineering controls
:
Local exhaust and general ventilation must be adequate to meet exposure standards.
Hand protection
:
Wear impervious gloves to minimize skin contact.
Eye protection
:
Safety glasses.
Skin and body protection
:
Wear suitable working clothes.
Respiratory protection
:
If airborne concentrations are above the applicable exposure limits, use NIOSH approved
respiratory protection.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state
:
Solid
Color
:
Multi-colored.
Odor
:
Odorless
Odor threshold
:
No data available
pH
:
No data available
Relative evaporation rate (butyl acetate=1)
:
No data available
Melting point
:
No data available
Freezing point
:
No data available
Boiling point
:
No data available
Flash point
:
No data available