Installation & Assembly

Attaching the canopy:
(Note: This is easiest with two people)
Step 1: Position canopy top so that canopy connectors are aligned with support poles. (fig.5)
Step 2: Insert support pole into canopy connector cap. Repeat with remaining poles. (fig.5)
Step 3: Extend the top telescoping to its full length.
Step 4: Pull canopy flaps together at each corner and affix with Velcro tabs.
To convert to sandbox cover: (Important : Lock each each lever before releasing next set of poles)
Step 1: Release the highest clamp on each pole. Canopy will now slide down to the next set of levers. Lock first lever, then
repeat with each additional level of clamps until the poles have fully telescoped into each other. (fig.6)
Step 2: To inhibit animal intruders, secure ties at base of cover.
To convert back to canopy:
Step 1: Release each bottom set of levers, then extend and lock first level of telescoping poles. Repeat with each
additional level.
Storing the canopy:
Step 1: Remove canopy from telescoping poles. Place on ground right side up (as it came off the support poles)
Step 2: Using your foot, step on the central hub to invert and unlock the canopy supports. (fig.7)
Step 3: Compress canopy sides together to close. (fig.8)
2
(fig.5) (fig.6)
(fig.7) (fig.8)