Instructions / Assembly

FENCE INSTALLATION GUIDE
Position the first fixing post support (A1).
Mark all 4 holes with a marker and drill 4 inches
into the concrete using a masonry drill bit (10mm
or 3/8”).
Fasten each anchor bolt (A2) to the fixing post
support by removing the nut and washers from
the bolt, then threading the bolts through the
bottom of the fixing post support. Fasten each
anchor bolt to the support using the nut and
washers. Once all 4 bolts are secured to the fixing
post support hammer all in, one strike at a time
each to keep the support level as it goes into the
ground.
Repeat this process to secure the second fixing
post support to the ground.
It is essential to have an 1800 mm (71”) gap on
center between the two fixing post supports.
(A) INSTALLATION WITH FIXING POST SUPPORT ON CONCRETE SLAB
Have an Issue or Question? Contact us first at:
[e-mail] or [phone]