Instructions / Assembly

FENCE INSTALLATION GUIDE
Once your posts are secured, insert the bottom
support rail (A10) into the slots of your posts
until it rests on the board stopper.
Then, slide the boards (A8) into the slots of the
post. Each board should nest into the one below
it. When installing the boards, it is necessary to
leave a gap of 9mm | 0.3 inches between the
fence board and the center rib of the posts on
each side (see the figure on right).
WARNING:
DO NOT INSTALL BOARDS UNDER THE GROUND
OR HAVE THE BOARDS TOUCH THE GROUND.
(B) INSTALLATION IN-GROUND CONCRETE FOOTING
Have an Issue or Question? Contact us first at:
[e-mail] or [phone]