Instructions / Assembly

(B) INSTALLATION IN-GROUND CONCRETE FOOTING
Before placing the posts into the holes, the board stopper
(A3) and Post Slot Cover (A7) need to be installed onto the
post.
Use the board stopper (A3) to mark holes on the aluminum
post.
Then using the marks, pre-drill holes into the post and secure
the board stopper with the screws provided (A4). The board
stopper must be above ground. Take care to precisely
measure to portion of post that will be underground and
install board stopper appropriately. The position of the board
stopper must be consistent across all posts and will
determine the amount of space under your fence panels.
If this post will be an end section or corner post, insert a post
slot cover (A7) into the appropriate slot.
Have an Issue or Question? Contact us first at:
[e-mail] or [phone]
FENCE INSTALLATION GUIDE