Instructions / Assembly

FENCE INSTALLATION GUIDE
Once your posts are secured, insert the bottom
support rail (A10) into the slots of your posts
until it rests on the board stopper.
Then, slide the boards (A8) into the slots of the
post. Each board should nest into the one below
it. When installing the boards, it is necessary to
leave a gap of 9mm | 0.3 inches between the
fence board and the center rib of the posts on
each side (see the figure on right).
(A) INSTALLATION WITH FIXING POST SUPPORT ON CONCRETE SLAB
Have an Issue or Question? Contact us first at:
[e-mail] or [phone]