Instructions / Assembly

Step 2: Install the Panel to the
Posts
Place a support, such as a board or bricks,
between the posts to act as a platform to
support the panel.
Position the panel between the 2 posts and
use the holes of the T-bracket to mark holes
on the post. Then, using a 3/16” drill bit,
pre-drill through both the composite sleeve
and steel inner post.
Once holes are pre-drilled, use the M4 x
25mm screws (Part F3) to secure the T-
brackets of the fence panel to the posts.
Finish your fence panel by securing a post
cap (Part B) on top of each post.
Have an Issue or Question? Contact us first at:
[e-mail] or [phone]
FENCE INSTALLATION GUIDE
(B) Pre
-
Assembled Panel Installation with Frame it All Post Assembly