Instructions / Assembly

Customer Service: 1800-914-9835 |
[e-mail]
© Frame It All. All Rights Reserved.
ASSEMBLY INSTRUCTIONS – Telescoping Canopy/Cover
FORMING THE CANOPY DOME
STEP 1: In an open area, position the canopy so that the inside of the canopy (with canopy
supports showing) is facing up.
STEP 2: Manually expands the canopy spokes evenly in each direction as much as
possible.
STEP 3: Using your foot, step on the center hub of the canopy to invert and lock the
supports in place. The canopy will ‘flip’ into its proper convex shape and become stable –
refer to image below.
INSTALLING THE TELESCOPING SUPPORT POLES (for
STEP 1: Unlock the clamps on the bottom two of the telescoping pole and extend it to its
full length. Lock the clamps to hold it in place.
STEP 2: Remove existing caps from stakes and replace it with caps that have holes to
receive the poles.
STEP 3: Insert widest end of the pole into recess of staking joint stakes – repeat with
remaining poles.
extend
ASSEMBLY INSTRUCTIONS – Telescoping Canopy/Cover
ATTACHING THE CANOPY (NOTE: 2-person job to make it much easier)
STEP 1: Position canopy top so that canopy connectors are aligned with support poles.
STEP 2: Insert support pole into canopy connector cap
(refer to image on left).
Repeat with remaining poles.
STEP 3: Extend the top telescoping to its full length.
STEP 4: Pull canopy flaps together at each corner and
affix with Velcro straps.
TO CONVERT TO SANDBOX COVER
Release the highest clamp on each pole.
Canopy will now slide down to the next
set of levels. Lock 1
st
lever, then repeat
with each additional level of clamps until
the poles have fully telescoped into each
other.
STORING THE CANOPY
STEP 1: Remove canopy from telescoping poles. Place on ground right side up (as it came
off the support poles.
STEP 2: Using your foot, step on the central
hub to invert and unlock the canopy supports.
TO CONVERT BACK TO CANOPY
Release each bottom set of levers, then
extend and lock 1
st
level of telescoping
poles.
Repeat with each additional level.
STEP 3: Compress
canopy sides
together to close.