Instructions / Assembly

Assembly Instructions
Trim stake spike
with hacksaw for
use indoor or on
hard surfaces
Note:
If you plan to assemble the Kit for use indoors or on a hard surface,
remove (with a hacksaw) the spike of each stake where indicated
on the diagram to the left. Use these cut down stakes for the base
level of your raised garden.
Do not do this if you are locating the Planter outdoors on soil.
Diagram 1
Diagram 4
SB
SB
SB
SB
PB
PB
PB
PB
FW
FW
4) Insert one Stake through the brackets into the aperture on the top of
the stake beneath it to lock the second level in place.
5) Add the Caps to each of the top corner joints to finish off the raised
garden. You can also locate Solar Lights (#SL-1025, sold separately)
as an added beauty feature, or frame-it-all’s cold greenhouses, veggie
wall or animal barriers.
1) Layout the base level of your raised garden in a
straight recangular shape, using 8 (PB) bracketed
timbers, insert one Stake through the brackets
and into each of the corners to lock all sides in
place (Diagram 1, at right).
Diagram 2
Diagram 3
2) For the second level, place two 4-way
bracketed timbers (FW) on top of the 1st level
(see diagram 2), then add a parallel-bracketed
(PB) timber on each end (diagram 3, below).
3) To complete the second level, place the (SB)
bracketed timbers with one bracket to complete
the sides and screw the unbracketed timber
sides into the channel of the 4-way bracket (see
diagram 4).