Instructions / Assembly

ManualsBrandsFrame It All ManualsGarden Center48 in. x 24 in. x 48 in. Stainless Steel Stack and Extend Animal Barrier

300001003

ANIMAL BARRIER

Stack &

Extend

Customer Service: 1800-914-9835 | support@frameitall.com

RAISED BED SOLD SEPARATELY

Each kit will protect a 4ft. x 4ft. garden to a height of 2

feet. Stackable & Extendable requires 2 or more kits.

KIT CONTAINS:

x 2

x 4

x 1

x 1 x 2

x 1

x 4 x 1

x 1

x 2

x 50

x 4

x 3

x 4

x 1

x 4

35mm

27mm

x 4

x 2

x 1

x 2

x 1

Summary of content (6 pages)

PAGE 1
300001003 ANIMAL BARRIER *Stack & **Extend RAISED BED SOLD SEPARATELY Each kit will protect a 4ft. x 4ft. garden to a height of 2 feet. Stackable & Extendable requires 2 or more kits. KIT CONTAINS: 3 2 1 4 35mm 5 7 6 8 27mm 35mm 27mm 35mm x2 9 x1 x2 x1 27mm x1 15 x 50 x4 x1 23 22 21 x3 x2 18 20 x4 x1 x1 14 13 19 17 x4 x2 12 11 10 x4 x1 x1 x4 x1 x4 Customer Service: 1800-914-9835 | support@frameitall.com © 2020 Frame It All. All Rights Reserved.
PAGE 2
ASSEMBLY INSTRUCTIONS Your animal barrier kit goes together by plugging the various tubes into the pivoting connectors and connecting the netting with zip ties.
PAGE 3
ASSEMBLY INSTRUCTIONS - continued STEP 3: Attach the gates to the raised bed boards Install gate stopper (12) with screws (11) on the inner side of the board to prevent the gate from swinging inward View from the inner side of the board.
PAGE 4
ASSEMBLY INSTRUCTIONS - continued STEP 5: Apply black netting to frame- work Apply the netting onto the remaining framework using zip ties. Attach top of netting flush with horizontal poles so the netting will hang over your raised bed. Attach zip ties all along the top horizontal steel tubes and vertical tubes as well. Customer Service: 1800-914-9835 | support@frameitall.
PAGE 5
ASSEMBLY INSTRUCTIONS – stack and extend Add additional kits to create a higher or larger barrier area. To stack another animal barrier – same way of assembling the barrier and use the additional round sleeves (part 22 – 1 sleeve is included in each pack). Slide the round sleeve (22) below the hinge connector Slide the round sleeve (22) below the short sleeve.
PAGE 6
ASSEMBLY INSTRUCTIONS – stack and extend (continued) To extend another animal barrier - where the door is parallel as the 1st barrier Remove bottom hinge connector (2) and replaced it with extension connector (23) Remove middle sleeve (8) and replaced it with hinge connector (7) Remove middle sleeve (8) and replaced it with hinge connector (7) Customer Service: 1800-914-9835 | support@frameitall.