Operation Manual

Frama Matrix F32/F42/F62

8.2.3. Info Print

In Admin mode, the Cost Centre report has extended

selection options for the cost centres to be printed. All

other reports and print options correspond to the de-

scriptions given earlier in this operating manual (see sec-

tion 5.6. Info Print from page 46).

Select CC List from Report CC. Enter the first cost centre

to be printed. Confirm the entry by pressing OK. Enter the

last cost centre to be printed. Press OK to confirm.

Insert envelopes, report cards, etc., into the feeder. One envelope/report card is printed per cost

centre.

8.2.4. Printer Settings

The Printer Settings menu item does not offer any additional functions in the Admin menu.

8.3. Counter Readings

You can display the counter readings of each cost centre shown in Admin

mode You can call up one cost centre or a list of cost centres for this func-

tion.

Select CC:

Press the key to call up the cost centre selection menu. Select the

cost centre.

CC list:

Here you can define a range of cost centres for the display of cost

centre data. First, enter the number of the cost centre from which the data

should be shown. Press OK. Then select the number of the last cost centre to be shown. Continue

to the Counter Readings menu using the arrow key. Press ESC to quit the display.

8.4. Setup 1

The Change PINs and Reset Counters functions apply to all cost centres in

Admin mode and therefore offer extended options. The Save Start Menu item

is not available in Admin mode.

8.4.1. Change PINs

Press the Change PINs key to change the PIN for Admin mode (Change PIN)

or to modify the PINs and names for other cost centres (Select CC).