Operation Manual

Frama Matrix F32/F42/F62
56
8. Admin mode
Settings made in Admin mode always apply to all cost centres. In Admin mode you also have ac-
cess to all cost centres and can thus conveniently make settings for these cost centres (counter
readings, name and PIN). The additional features demanded by Admin mode are described below.
Tip
You can also make settings in each cost centre. However, when you do this not all the Admin
mode functions are available to you.
8.1. Log in
Admin mode is selected by pressing the Admin key from
the Select Cost Centre screen. This mode is always pass-
word-protected, even if you have switched off PIN Code
entry for the cost centres.
Press the Admin key to access Admin mode. Enter your
PIN. The default PIN is 1234.
Confirm your PIN Code input by pressing OK.
Tip
Save the PIN for Admin mode in a safe place. The PIN can only be reset by a service techni-
cian at your premises or in the central workshop. This service is chargeable.
8.2. Main Menu
You are taken to the Main Menu after logging in. Franking is not possible in Admin mode. The Ad-
min functions in the Main Menu are described below.
8.2.1. Devices
8.2.1.1. Feeder
Specify the inserter mode settings for the system globally.
The other functions in the Feeder menu do not differ from the descriptions from page 33.
8.2.1.2. Scales
There are no special features in Admin mode.
8.2.2. Logo
Specify the logo setting for the system.
The other functions in the Logo menu do not differ from the descriptions from page 40.
Tip
Only those settings that you have defined as SYSTEM in the Setup 3 menu, such as the logo
and the settings for the AF feeder, can be adjusted.