Operation Manual

Frama Matrix F32/F42/F62

5.7.3. Service

The service station is run under the print head after a specified time if you briefly interrupt franking,

e.g. because you are inserting new mail items. This means that there is a delay after new mail items

are inserted in the machine, as the station must first be parked again.

You can use the Service setting to define the time that the franking system waits before the service

station is run under the print head. In this way you are able to adjust the behaviour of the

F32/F42/F62 to your way of working.

This setting does not affect the automatic seal after 1 minute's open time.

The following settings are possible:

SHORT = 10 second delay (default)

NORMAL = 20 second delay

LONG = 30 second delay

5.7.4. Label alignment

Use this function to run the adjustment of the print quality for franking labels separately. Normally,

alignment is run as part of the configuration following a change of print head.

5.7.5. Changing the ink jet cassette

Information

Caution Make sure that the ink jet cassette has been stored at room temperature for at least

three hours before you fit it.

Press the Change Ink Jet Cassette key in the Main Menu

and confirm by pressing YES.

Open the top cover flap. Remove the ink jet cassette by

squeezing together the grip surfaces on the cassette and

pulling it out upwards.

Follow the instructions on page 29 to install and align the

new ink jet cassette and print head correctly.

5.7.6. Print Alignment

Use this function to run the adjustment of the print quality for franking separately. Normally, align-

ment is run as part of the configuration following a change of ink jet cassette.

5.7.7. Print Head New Calibration

Recalibrate the print head (ink jet cassette) if the overall print quality is not satisfactory.