Operation Manual

Frama Matrix F32/F42/F62
38
4.6.7. Separating/connecting the feeder and franking system
Danger
1. First switch the franking system off, and then pull out the mains plug before you separate
the feeder from the base of the franking machine. There is a risk of electric shock and inju-
ry.
Information
1. Remove the water tank and the optional letter sealer before you separate the automatic
feeder from the base of the franking machine. Incorrect transport may otherwise lead to
water damage.
2. Always separate the franking system base and the feeder if you wish to transport or ship
the franking system.
3. Failure to do so may cause the destruction of the franking system.
4. Check that the feeder is fitted properly before using the machine again.
4.6.7.1. Disconnecting the franking system
Observe the safety instructions. If the feeder is fitted with the optional letter sealer, the letter sealer
must be removed as described on page 35.
Information
Always ensure that you have disconnected the machine from the mains before you
make or break the mechanical connection between the feeder and the franking sys-
tem. Failure to do so may cause the destruction of the franking system.
Switch the franking system off. Remove the mains lead and the water tank.
Press the release button (see also figures 4 and 5
on page 39) and withdraw the feeder to the right.