Operation Manual

Frama Matrix F32/F42/F62

4.5.2. Topping up the franking labels

4.5.2.1. AF/AFS automatic feeder (MatrixF62 only)

Open the label compartment on the AF feeder by lifting up the cov-

er flap. Hook a finger under the cover flap and lift it up. Open the

flap completely upwards.

Hold the top end of the hook clamp with the left hand and pull it

upwards. Keep the hook clamp in this position. Remove the empty

label box, if necessary.

Put the label box into the channel. Push the front open end of the

label box under the bottom part of the hook clamp. Then you can

release the hook clamp.

This is how it should look if you have put the label box properly into

place. Close the top cover flap again. The strip dispenser is now

functional.

4.5.2.2. Manual feeder (Matrix F42 only)

Open the label dispenser cover on the feeder by lifting up the cover

flap to the right. Push the lock to the right with one finger and lift the

flap. Now open the flap fully to the right.

Insert the label box to the left. To do this, press the labels down

lightly with one finger to prevent them slipping out. Push the box in

to the left as far as the stop.

This is how it should look. You can keep a spare box in the front

compartment.