Operation Manual

Frama Matrix F32/F42/F62

Example of a test print:

Alignment X is shown on the left and

Alignment Y on the right. The setting

currently valid for each is indicated

by an arrow. The arrows should point

to where the lines appear straightest.

If this is already the case, you only need to confirm the following displays X and Y by pressing the

ENTER key. Sometimes, however, it is necessary for you to change the setting to optimize the re-

sults. Simply carry out the additional instructions.

This is how you should proceed: Look for the line that appears to be straight-

est in the Alignment X area to the left of the test mark. Note the number be-

neath it,

e.g. -1.

Use the + and - keys to select the right number in the display and then press

ENTER to go to the Y setting.

Again use the + and - keys to select the right number in the display and then

press ENTER.

Run a test print again when prompted to check your settings. The arrows will

now point exactly to the settings you made, i.e. right where the lines should

be straightest.

If you are still not satisfied, you can reset again by answering the prompt with

NO. Press YES to save the alignment setting.

If your franking system is fitted with a label dispenser, this is now followed by

the same procedure for aligning the printed image on the labels. To do this,

follow the instructions on the screen.