Operation Manual

Frama Matrix F32/F42/F62
27
4.4. Franking
Information
Use distilled water or hardness degree 1 water if you are using the optional letter sealing unit.
Using water of higher hardness grades shortens the letter sealing unit's service life.
It is only possible to frank mail items when the Ready prompt (letter icon) is showing in the display
(see page 12).
4.4.1. MF/MFD manual feeder (Matrix F32/F42 only)
The MF/MDF manual feeder supports FeedControl which ensures that your
mail items are always franked correctly. As a result, invalid franking is now a
thing of the past.
To feed in mail items, lay the mail item flush against the rear boundary of the
feed table. Push the mail item to the left into the Matrix franking system. The
feed rollers pull in the mail item and frank it.
Mail items fed in at an angle are not franked thanks to FeedControl. Feed in
these mail items again to have them franked correctly.
Danger
1. Use accessories intended for this system only. The use of accessories that are not ap-
proved, or not authorized, can be detrimental to the service life of the franking system.
At the same time, a danger to the operator can be created.
2. Always keep your fingers and other parts of the body, ties, necklaces, scarves, open
sleeves and similar loose things away from the feed entry area and the feed rollers. There
is a risk of injury on rotating parts.
3. Do not clean the system with flammable fluids. There is a risk of explosion.
4. Disconnect the system from the mains before cleaning it. Clean the system with a damp
cloth only. Do not spray any liquids on or into the franking system. There is a risk of
electric shock. Lethal hazard.
5. Do not place any liquids, glasses, franking ink, etc. on the franking system.
6. Do not fill the tanks on the sealing device with any flammable liquids. Risk of explosion.