Operation Manual

Frama Matrix F32/F42/F62
15
2.6. Connecting to the mains electric supply
Danger
1. Check the franking system for external damage before setting it up. You may be putting
your life at risk by using a damaged machine.
2. Check the cable and plug before installing the system. Have any damage repaired by a
specialist electrician only. Do not use the machine until the damage has been repaired.
3. A damaged connecting lead may only be replaced by a lead of the same type.
4. Only connect the plug into a mains socket when the franking machine housing is closed.
5. Always run the mains cable away from the rear of the franking machine and make sure that
no risk exists of it being damaged or someone tripping over it.
6. Never pull the plug out of the socket by the mains cable.
Make sure that you have closed all the covers on your Ma-
trix franking system. Make sure the scales platform is not
obstructed. Check that the system is switched off (0 must
be pressed down).
Pick up the mains cable (power cord). Plug the cable into
the mains socket (jack), as shown in the above photo.
Connect the other end of the mains cable to a suitable
earthing contact socket.
2.7. First use
Switch the franking system on You will hear various sounds during the switch-on routines. All the
motors and sensors are being checked.
Information
Information: The switch-on routines may take some time. During this time, the Frama Matrix
franking system will not accept any input from you.
The franking system must now be installed (registered) with the FramaOnline2 data centre.