Operation Manual

Frama Matrix F32/F42/F62
13
2. Installation
In the normal event, the machine will be installed by a member of our after-sales technical team.
You must also follow the steps in the installation instructions enclosed separately if you wish to
install the machine yourself.
There are four steps to installation:
1. Assembly of the individual components
2. Registering with the FramaOnline2 system
3. Configuring the printer settings
4. Loading postage credit
The information and safety notes below are only a quick reference guide.
2.1. General notes and safety information
Select a position near a mains socket and an Ethernet connection (RJ45) for Frama Matrix franking
system. Avoid direct sunlight and severe vibration.
Draughts can affect the accuracy of the scales.
Your Frama Matrix franking system was manufactured for use in normal conditions. Remember:
Today’s furniture is coated with a confusing variety of paints, lacquers and synthetic materials. In
view of this, it is quite possible that some of these materials contain constituents which can attack or
soften the plastic feet of our equipment. The feet of our equipment, if affected by foreign substanc-
es, can stain your furniture. Frama is unable to accept any liability in this respect for obvious rea-
sons.
With this in mind, use a non-slip underlay.
2.2. Connecting the feeder and franking system
Information
Always ensure that you have disconnected the machine from the mains before you
make or break the mechanical connection between the feeder and the franking sys-
tem. Failure to do so may cause serious damage to franking system. Further informa-
tion is available on page 38.