Operation Manual

Frama Matrix F4 / F6
48
6.3. Renaming cost centres and changing PIN
6.3.1. Changing cost centre PIN
As standard, a PIN protects the cost centre. In the as-delivered state of the franking system, the PIN is the
same as the cost centre number. The PIN can have up to 8 digits.
To change a cost centre PIN, proceed as follows:
Press the key “Change PINs/Names”. In the admini-
stration mode, you can now select the cost centre
to be changed. In cost centre mode you can only
change the setting of the current cost centre.
Press “Change PIN”
Enter the new PIN.
Enter the new PIN again.
The PIN of the selected or current cost centre has
thus been changed.
In the administration mode, you have acess to all
cost centres.
6.4. Changing cost centre name
Your Frama Matrix franking system offers you the possibility of assigning an individual name to each cost
centre. It is already shown in the cost centre selection and simplifies your work.
Select “Change Account Name”.
Proceed further as described in chapter 5. Refer to
the section “Enter text”.