Operation Manual

Frama Matrix F4 / F6

6.2. Cost centres and cost centre management in administration mode

Settings made in the administration mode always apply to all cost centres. In the administration mode,

furthermore, you have access to all cost centres and can thus conveniently make settings for these cost

centres (counter readings, name and PIN).

You can also make settings in the respective cost centre. When doing so though, not all

functions of the administration mode are available to you.

6.2.1. Displaying cost centre data in administration mode

In the administration mode, you have access to all cost centres and can thus name, change or issue new

PINs as well as print out the counter readings for these and let them be displayed as well as, of course,

reset them.

Choose “Admin” in the cost centre selection.

Enter your PIN. Then, press the OK key to get into

the administration mode.

Press “i”.

You can have the counter readings of every cost

centre shown to you in this menu. In this respect,

you can fetch one cost centre or a list of cost cen-

tres.

Select CC: Press the key to fetch the cost centre

selection menu. Select the cost centre.

CC list: In this case, you can define a range of cost

centres for the display of cost centre data.

First enter the number of the cost centre from

which the data should be shown. Press OK. After-

wards, select the number of the cost centre which

should be shown last.

Advance in the counter reading menu using the

arrow key. Press ESC to quit the display.