Operation Manual

Frama Matrix F4 / F6

3.2. Setting franking mark

If you have put the new cartridge properly into place, you can now press

“Yes” on the display.

The inkjet cassette will now be tested and calibrated. This process might take a

few seconds. During calibration, the display shown oppposite will appear.

If the inkjet cassette being used was already in place in your Matrix franking

system, you can choose between recalibration and taking over the existing

calibration data. Recalibration can be necessary if the initial calibration did not

result in a satisfactory franking mark, e.g. the printing head was too cold, etc.

After calibration, you will be asked to print a test franking mark. Pick up an envelope or a folded A4 sheet

of paper. We recommend that you use a filled envelope.

Lay the envelope / paper to be franked on the manual feeder MF4 or in the

automatic feeder AF6.

The envelope / paper, etc. will be franked with a test mark and ejected to the

left.

This is how the test mark should look

On the left hand side, you can see setting X

and on the right-hand side setting Y. The

setting valid at the time is indicated by an

arrow. The arrows should point where the

lines appear to be “straightest”.

If this is already the case, you only need to confirm the following X and Y displays by pressing the ENTER

key. Sometimes however, it is necessary for you to change the setting to optimize the results. Simply carry

out the additional instructions.