Operation Manual

Frama Matrix F4 / F6

2. Installing FramaOnline2

Loading your Frama Matrix franking system with new postage (credit) takes place through the telephone

line and a built-in analogue modem. Simultaneously, the postal rate information can be compared / ad-

justed. This process is convenient and gives you the assurance of always having postage and the latest

postal rates at your disposal.

You will require your PIN for the administration mode as well as your Frama on-line2

activation (safety) code which was mailed to you under separate cover. You cannot

activate your system for FramaOnline2 operation without this number.

The FramaOnline2 safety code is used solely for activation. Protect your PINs from misuse by keeping them

in a safe place. If you forget or mislay your PIN codes, they can be read out only in the Frama Central

Workshop.

2.1. Activating Frama Matrix on FramaOnline2 system

Check whether your Frama franking system is properly plugged into the telephone socket. If necessary,

read the chapter “Connection and start-up“ again. The franking system has to be connected to the tele-

phone socket only when linking with the framaonline2 system and re-crediting.

Fetching postage and communicating with FramaOnline2 are possible only in the administration mode.

Caution! The administration mode is password (PIN) protected. Use the PIN you received in a separate

letter.

We have preconfigured your Frama franking system to suit the most used telephone systems. Sometimes

though, it will be necessary for small changes to be made. The most frequent setting will be the dialling

code (official prefix for an outside line) to obtain the free line signal. Please refer to point 8.6.1 in this

respect. In the as-delivered state, NO dialling code (official prefix for an outside line) has been configured.

(i.e. 9 for outside line).

The following steps assume that you have correctly entered the dialling code (official prefix for an outside

line).

1. Press “Admin” in the cost centre selection

display.

2. Enter your PIN for the administration mode.

Then, press the OK key to get into the admini-

stration mode.

3. Press “i”.

4. Press the “Tool key”.