Operation Manual

Frama Matrix F4 / F6

1.4.3. Connecting an external PC solution (optional)

Use the socket (jack) marked “PC“ for connecting an exter-

nal PC solution for data transfer. Please refer to the instruc-

tions in the operating manual of the external PC solution.

1.4.4. Connecting to main electric supply

Check that you have closed all covers and flaps on your

Matrix franking machine. Make sure the scales platform is

not obstructed. Check that the system is switched off (0

must be pressed in).

Pick up the mains cable (power cord). Plug the cable into

the mains socket (jack), as shown in the above photo.

Connect the other end of the mains cable to a suitable

earthing contact socket.

1.5. Switching on franking system

Switch on the franking system. You will hear various sounds after switching

on. All motors and sensors are being checked.

Caution! After switching on, some time might pass until the sytem

is ready. During this time, the Frama franking system will not

accept any input from you.

Your next step is to put in and calibrate the inkjet cassette. This process is ab-

solutely essential to obtain frank marks of excellent quality and it must there-

fore be carried out carefully.