Operation Manual

Frama Matrix F4 / F6
11
1.3.1. Fitting letter guide (optional)
The letter guide is an optional accessory for use when franking mail items larger than C4 with portrait
format. It is not an integral part of what is delivered with the feeder AF6.
The letter guide consists of two parts. Join the parts and fit the guide into the holders provided (one on
the AF6/AFS6 and one on the franking system).
1.3.2. Inserting franking labels into automatic feeder AF6/AFS6
Open the label compartment on the feeder AF6 by lifting up the top
cover flap. Hook a finger under the cover flap and lift it up. Open the
flap completely, upwards.
Hold the top end of the hook clamp with the left hand and pull it up-
wards. Keep the hook clamp in this position.
Put the label box into the channel. Push the front open end of the label
box under the bottom part of the hook clamp. Then, you can release the
hook clamp.
This is how it should look if you have put the label box properly into
place. Close the top cover flap again. The label system is now functional.
1.3.3. Filling water into tank of automatic feeder AFS6 closing device (AFS6 only)
If you decided in favour of the option “Sealer” when purchasing your AF6 (it can also be added later), you
should now fill the water tank of the closing device. Please use distilled water (recommended).
Caution! Never use washing-up liquid additives or other additives which reduce the water
surface tension. Water with a high overall hardness causes a shortening of the servicing
intervals and should thus be avoided.
From time to time, the sealing felt must be cleaned or renewed. In this respect, please refer to chapter
5.1.1.2.