Operation Manual

Frama Matrix F4 / F6
20
This is how you should proceed: On the left-hand side of the test mark, X, look
for the line which seems to be “straightest. Note the number beneath it,
e.g. “0“.
Use the + and - keys to select the right number in the display and then press
ENTER to go to the Y setting.
Again, but this time for the Y setting, use the + and - keys to select the right
number in the display and then press ENTER.
Once more, as requested, print a test franking mark to check your settings.
The arrows will now point exactly at the settings you made, i.e. right where
the lines should be “straightest”.
If results are not satisfactory yet, you can repeat the setting procedure by an-
swering “NO”. To save your settings, confirm with “YES”.
If your franking system has a label dispenser, you can set the label printout
format the same way. Just follow the instructions on the monitor.
This completes your franking system installation.