Operation Manual

Frama Matrix F22
43
8.2. Main Menu
You are taken to the Main Menu after logging in. Franking is not possible in Admin mode. The
Admin functions in the Main Menu are described below.
8.2.1. Devices
8.2.1.1. Scales
There are no special features in Admin mode.
8.2.2. Logo
Specify the logo setting system-wide (to do this, in the Setup 3 menu, activate Logo: System.
The other functions in the Logo menu do not differ from the descriptions from page 29
8.2.3. Info Print
A list of all the cost centres can be printed out using the Report CC key in
Admin mode. All other reports and print options correspond to the
descriptions given earlier in this operating manual (see section 5.5. Info Print
from page 33).
8.2.4. Printer Settings
The Printer Settings menu item does not offer any additional functions in the Admin menu.
8.3. Counter Readings
You can display the counter readings of each cost centre shown in Admin
mode. You can call up one cost centre or a list of cost centres for this function.
Select CC: Press this key to call up the function. Select the cost centre.
CC list: Here you can define a range of cost centres for the display of cost
centre data. First, enter the number of the cost centre from which the data
should be shown. Press OK. Then select the number of the last cost centre to
be shown. Continue to the Counter Readings menu using the arrow key. Press
ESC to quit the display.
Tip
Only those settings that you have defined as SYSTEM in the Setup 3 menu, such as the logo,
can be adjusted.