Operation Manual

Frama Matrix F22

7.2. Setup 2 menu

Setup 2 menu can only be called up in Admin mode (see page 42).

7.2.1. High Value

This setting determines that amount from which, for security reasons, you

must confirm the postage value before this amount can be franked. The

default setting is £10.00. Enter the new value and confirm your input by

pressing ENTER.

7.2.2. Max. Value

Define the maximum permitted franking value with this setting. Press the key, enter the value and

confirm by pressing OK or ENTER (default = £100.00).

7.2.3. Key Beep

Used to switch the key beep on and off. Press the key to switch the beep ON or OFF. This setting

also affects the signal in batch weighing (default = ON).

7.2.4. Auto Log off

Use this function to define the time until the current cost centre is closed and the Select Cost Centre

screen is called up. Entering 0 minutes switches this function off (default = 10 minutes).

7.2.5. FramaOnline2

The FramaOnline2 functions are explained in detail from page 45.

7.2.6. Low Credit

This setting checks the amount of postage available and warns you in good time that the level is

getting too low. Press the Low Credit key to change this setting. Enter the new value. Confirm your

change by pressing OK (default = £100.00).

7.2.7. PIN Code

Used to switch the PIN input on or off. The PIN Code ON setting means that a PIN must be entered

in the Select Cost Centre function. The PIN Code OFF setting switches off the request for PIN Code

input. The Admin mode is not affected by this.

7.2.8. Delete CC

Here you can specify whether the cost centres may be deleted outside Admin mode.