Operation Manual

Frama Matrix F22
14
2.4. First use
Switch the franking system on. You will hear various sounds during the switch-on routines. All the
motors and sensors are being checked.
Information
Information: The switching-on routines may take some time. During this time, the Frama
Matrix franking system will not accept any input from you.
The franking system must now be installed (registered) with the FramaOnline2 data centre.
2.5. FramaOnline2 installation
Your Frama Matrix F22 is loaded with postage (credit) through the network connection. At the same
time, postage rates are updated and any postage data is transmitted to Royal Mail. This process is
convenient and gives you the assurance of always having postage and the latest postage rates at
your disposal.
Tip
It is only possible to fetch postage and communicate with FramaOnline in Admin mode.
Tip: The Admin mode is password (PIN) protected. Keep your PIN in a safe place. The PIN
can only be reset in a chargeable call-out of a service technician to your premises or in the
central workshop.
Check that your franking system is correctly connected to your local network. If necessary, read the
Connection and start-up section again. The franking system need only be connected to the network
while it is being activated and postage is being downloaded.
It is only possible to download postage funds and communicate with FramaOnline in Admin mode.
Caution: The Admin mode is password (PIN) protected. Use the PIN you received in a separate
letter.
Information
Information: It may be necessary to configure your franking system to ensure that it connects
successfully with your network. Follow the instructions on page 18 to make the necessary
settings.
1. Press Admin in the Select Cost Centre display.