Operation Manual

Frama Matrix F22
13
2.2.1. Make communications connection (communications module)
The connection of the relevant cable differs depending on the communications module used.
Ethernet (green): Plug the network cable (RJ45) into this socket. Plug the network cable into your
network.
2.2.2. Connecting the scales (optional)
Plug the scales cable into the scales socket. Look in the operating manual for the scales if
necessary.
2.3. Connecting to the mains electric supply
Danger!
1. Check the franking system for external damage before setting it up. You may be putting
your life at risk by using a damaged machine.
2. Check the cable and plug before installing the system. Have any damage repaired by a
specialist electrician only. Do not use the machine until the damage has been repaired.
3. A damaged connecting lead may only be replaced by a lead of the same type.
4. Only connect the plug into a mains socket when the franking machine housing is closed.
5. Always run the mains cable away from the rear of the franking machine and make sure that
no risk exists of it being damaged or someone tripping over it.
6. Never pull the plug out of the socket by the mains cable.
Take the power supply unit.
Then connect the cable with the small right-angled round plug to the Matrix
F22 (see photograph).
Make sure that the plug clicks into place properly. This will be the case when
the cable is flush against the housing.
Make sure that you have closed the top flap on the Matrix F22. Check
whether the scales are free to move.
Information
Information: The switch-on routines may take some time. During this time, the Frama Matrix
franking system will not accept any input from you.