Operation Manual

Frama Matrix F2
9
2. FramaOnline2
The following information given in this whole chapter is for reference only. Your Frama
franking machine will be installed by a service engineer.
Loading your Frama Matrix F2 with new postage (credit) takes place through the telephone line and a
built-in analog modem. At the same time, postal rates can be compared / updated and other postal
data is transmitted to the Post Office. This process is convenient and gives you the assurance of always
having postage and the latest postal rates (optional) at your disposal.
In any event, you require your PIN for the Administration mode. Protect your PINs from misuse by
keeping them in a safe place.
2.1. Activating Matrix F2 on FramaOnline2 system
Check whether your Frama Matrix F2 is properly plugged into the telephone socket. If necessary, read
the chapter 1.3 “Connection and start-up“ again. The franking system has to be connected to the
telephone socket only when linking with the FramaOnline2 system and re-crediting.
We have preconfigured your Frama Matrix F2 to suit the most used telephone systems. Sometimes
though, it will be necessary for small changes to be made. The most frequent setting will be the dialing
code (official prefix for an outside line) to obtain the free line signal. Please refere to page 11 in this
respect. In the as-delivered state, NO dialing code (official prefix for an outside line) has been
configured. (i.e. 9 for outside line).
The following steps assume that you have correctly entered the dialling code (official prefix for an
outside line).
1. Press “Admin” in the cost centre selection display.
2. Enter your PIN. Then, press the ENTER key to get into the
administration mode.
3.
4. Press “  ”.
5. Press the “Tool” key (symbol).