Operation Manual

Frama Matrix F2

1.1. Installing Matrix F2

Install your Frama Matrix F2 in a place near a mains socket and a direct fax / modem telephone

connection. Select a place without direct sunshine and no heavy vibration. Take all parts out of the

box.

1.2. Connecting modem cable

Connect the modem cable (small square plug) with the Matrix F2 at the

socket (jack) marked with the telephone symbol.

Afterwards, connect the other end of the telephone cable with the

telephone point.

When starting up the first time, we recommend that you use an existing analogue fax connection.

1.3. Connecting scales

A weighing scale that is included with the system must be connected in

order for the system to function. Unpack the scales and, if required, the

scales support available as an accessory at additional cost. Position the

scales next to your Matrix F2 or on the scales support.

Connect the scales cable to the scales connection, which is also at the back of the Matrix F2 and

marked with a scales symbol.

1.4. Connecting supply unit

Pick up the power supply unit. Connect the

supply unit with the supplied adaptor (mains

plug).

Then, connect the cable with the small plug to

the Matrix F2 (see photo).

Make sure the plug fits into place properly. This

is the case when the cable is flat against the

housing.

Check that you have closed the top cover flap

on the Matrix F2. Check whether the scales are free.

Connect the supply unit to the mains socket.

Caution! It can take up to 30 seconds for the Matrix F2 to switch on. During this time, the Frama

F2 will not accept any input from you.