Operation Manual

Frama Matrix F2

8.1.3. Set-up 3 menu

1. Beep ON/OFF: This serves to switch the key beep on and

off. Pressing “Beep on“, switches off the beep. Pressing

again, switches the beep on again.

2. Switching CC Clear ON / OFF: Using this function, you

can define whether the users of the individual cost

centres may or may not delete their cost centre contents

(counter number and value readings). Select “CC Clear OFF“ so that only you are allowed to delete

counter readings in the administration mode.

3. Stand by ON / OFF: This is for switching the “Stand by“ function on and off as well as for

programming the time lag before the system switches itself into the standby mode.

Switching standby on and programming standby time lag: Press the “Standby“ key. Enter the

desired time lag before the system should switch to standby. If “0 minutes” is entered, the

function switches off. Press “ENTER” to acknowledge.

8.1.4. Restarting system

For your changes to become effective, you have to restart your Frama Matrix F2. To do so, use the

function “Start up /Log off“ in the Setup 1 menu.