Operation Manual

Frama Matrix F2
35
8. Administration mode (settings)
First and foremost, the administration mode serves the adjustment of your Matrix F2 which, in many
respects, you can adapt to suit your needs. You cannot frank when you are in the administration mode.
Settings made in the administration mode always apply to both CC accounts Furthermore, it is only
possible for you to link up with the FramaOnline2 data centre when you are in the administration
mode. The following explains in detail the individual functions in the administration mode.
You can also make settings in the respective CC accounts. When doing so though, not all functions of
the administration mode are available to you.
8.1. Maintaining basic settings and cost centres
Proceed as follows to change the basic settings of your Matrix F2:
1. Choose “Admin” in the cost centre selection.
2. Enter your PIN. Then, press the ENTER key to get into the
administration mode.
3. Press “i”.
4. The total counter readings of each cost centre and the
system are displayed in this menu. Press cost centre 1 to
have the values of this cost centre displayed. Proceed in
the same way for cost centre 2. The overall counter
readings are displayed if you press “System“.
5. Press the “Tool” key (symbol) to obtain the basic settings.
The basic settings are divided among three menus. These
are designated Set-up 1, Set-up 2 and Set-up 3.
By pressing the arrow, you can go forward and return by pressing ESC.
The basic settings are divided among the menus Set-up 1, 2 and 3. Each menu describes the functions
and the possibilities for selection.